Onkyo Before Using the DV-CP701, Installing the Remote Controller’s, Batteries, Notes

Before Using the DV-CP701

Installing the Remote Controller’s	Using the Remote Controller
Batteries	To use the remote controller, point it at the DV-CP701’s
	remote control sensor, as shown below.
1 Open the battery compartment, as shown.
	Remote control sensor
	DV-CP701

2	Insert the two supplied batteries (AA) in	30˚
	accordance with the polarity diagram inside	30˚

the battery compartment.

3 Close the battery compartment.

Notes:

•The supplied batteries should last for about six months, although this will vary with usage.

•If the remote controller doesn’t work reliably, try replacing both batteries.

•Don’t mix new and old batteries, or different types of bat- teries.

•If you intend not to use the remote controller for a long time, remove the batteries to prevent possible leakage and corrosion.

•Flat batteries should be removed as soon as possible to pre- vent possible leakage and corrosion.

Notes:

•The remote controller may not work reliably if the DV- CP701 is subjected to bright light, such as direct sunlight or inverter-type fluorescent lights. Keep this in mind when installing the DV-CP701.

•If another remote controller of the same type is used in the same room, or the DV-CP701 is installed close to equip- ment that uses infrared rays, the remote controller may not work reliably.

•Don’t put anything, such as a book, on the remote control- ler, because the buttons may be pressed inadvertently, thereby draining the batteries.

•The remote controller may not work reliably if the DV- CP701 is installed in a rack behind colored glass doors. Keep this in mind when installing the DV-CP701.

•The remote controller will not work if there’s an obstacle between it and the DV-CP701’s remote control sensor.

15