Connect handle and tank
|
| ||
|
|
|
|
A
2. How to use
Polarized plug
1.Remove bright plated (top) screw from back of tank housing.
2.Position handle as shown lining up holes (A). Push handle down firmly into place. Do not grip trigger or twist han- dle while installing.
Insert screw and tighten.
3.The tank fits into the opening in the front of the tank housing. Place bottom of tank into position, then push top of tank until it clicks into place.
To reduce the risk of electric shock, this appliance has a polarized plug (one blade is wider than the other). This plug will fit in a polarized outlet only one way. If the plug does not fit fully in the outlet, reverse the plug. If it still does not fit, contact a qualified electrician to install the proper outlet. Do not change the plug in any way.
Control button
The control button, located on the handle, has three positions: “OFF”,
The unit is off when the control button is moved back to the “OFF” position.
|
|
| ||
|
|
|
|
|
To scrub, polish or shampoo , | For wet pickup, move the control |
move the control button to the right and | button to the left and then forward to the |
then forward to the | “WET PICKUP” position. |
SHAMPOO” position. | NOTE: Before changing from one posi- |
| |
| tion to the other, always return control |
| button to the “OFF” position. |
Tank
The tank has one section for storage of fresh cleaning solution and one section for storage of dirty solution that has been picked up from the floor.
To fill tank
Remove tank by pressing tank handle down and pulling tank forward.
Lift cap marked “FILL”. Pour
To empty tank
To empty dirty solution, remove tank and pour from the opening marked “USED SOLUTION’’. Rinse used solution
container with clear water. Clean solu- |
|
tion may be emptied by opening “FILL” |
|
cap and pouring from the “CLEAN |
|
SOLUTION” opening. | 4 |
|
