HANDLE
RELEASE
PEDAL
Step on handle release pedal and lower deep cleaner handle until it rests on the floor.
Unlatch back part of recovery tank lid and remove lid.
FRONT
PANEL
Remove recovery tank front panel by sliding it straight up.
CONVERTER
Replace panel with converter. Slide converter halfway down opening until it is firmly in place.
SOLUTION
TUBE
Before connecting tube to cleaner, make sure black tabs are extended by pulling tan collar toward tube.
Open door on hood labeled “Stair/Upholstery Cleaning Connection”. Press round solution tube connector onto round projection inside door.
Press connector collar down firmly to ensure that it is fully connected.
10
TABS
FRONT
The tank lid replaces in a
Make sure lid is secure on all sides before cleaning.
For full suction, it is important that the recovery tank lid is properly secured before cleaning.
Reverse procedure to remove hose and solution tube.
Raise deep cleaner handle to upright position and replace upper clean solution tank.
TAB
LATCH
Attach nozzle to connector end of hose by sliding it onto connec- tor until the tab locks it securely.
Using your thumb, push forward and up on the latch to remove nozzle.
Follow the instructions on pages
After using stair/upholstery nozzle
Follow the instructions for “After cleaning” on page 8.
Drain suction hose by turning deep cleaner ON and holding nozzle up for several minutes. Do not press trigger.
Disconnect deep cleaner from electrical outlet. Disconnect hose and solution tube from deep cleaner.
Drain solution tube by placing round end in sink, and raising nozzle above your head. Press the trigger.