Cleaning bare floors
Some models come with the bare floor attachment. For others, the attachment is available at additional cost from your Autho- rized Hoover Dealer (Depot) or Hoover Factory Service Center.
How to attach bare floor attachment
Disconnect deep cleaner from electrical outlet.
TANK
HANDLE
To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture.)
HANDLE
RELEASE
PEDAL
LATCH
Step on handle release pedal and lower handle until it rests on the floor.
Rotate recovery tank latches outward (one on each side of tank). Lift tank off machine.
FOAM STRIP |
NOZZLE |
With handle in the upright position, tilt deep cleaner back so that handle rests on the floor.
Place attachment on front of nozzle with foam strip (under netting) in position as shown.
Push attachment against nozzle while rotating attachment downward until both ends “snap” into place.
(Note: Some force may be required to rotate and snap attachment into place.)
Return deep cleaner to upright position.
LATCH
Lower handle and replace recovery tank. Press down to ensure that it is properly seated in place.
Rotate latches (one on each side of tank) inward to lock tank in place. Raise handle to upright position and replace upper clean solution tank.
To clean floor
Read “Before you begin cleaning” instructions on page 7. Do not use deep cleaner on hardwood floors.
Fill clean solution tank according to instructions on pages
type of wax with your deep cleaner.
Dry hands and plug deep cleaner into a properly grounded outlet.
Step on handle release pedal and lower handle to operating position. Turn deep cleaner ON.
To release solution, squeeze trigger. Slowly move deep cleaner forward and backward over area to be cleaned.
To pick up dirty solution, release trigger and slowly move deep cleaner over area where solution has just been dispersed. Use both forward and reverse strokes.
When finished cleaning, follow “After cleaning” instructions on page 8.
Remove attachment from nozzle and rinse in clear water. Do not remove plastic screen or foam from attachment.
Using the stair/upholstery nozzle
How to attach hose
Disconnect deep cleaner from electrical outlet.
TANK
HANDLE
To prevent possible leaking, remove clean solution tank by pressing down on tank handle and pulling forward; set tank aside (do not set tank on furniture). Continued ➜ 9