Hoover Deep Cleaner owner manual Service, Cleaning carpeted stairs

CONVERTER

CONVERTER

CLIP

Occasionally, debris may become lodged inside of the hose at the converter end.

To clean-out the hose, lift bottom of converter clip with a screw driver and remove clip. Remove debris as shown.

SOLUTION

HOSE

Snap clip back into position making sure solution hose is not pinched and moves freely.

Replace recovery tank front panel. Slide panel down until it snaps firmly in place.

Service

To obtain approved HOOVER service and genuine HOOVER parts, locate the nearest Hoover Factory

Service Center or Authorized Hoover Warranty Ser- vice Dealer (Depot) by:

•checking the Yellow Pages under “Vacuum Cleaners- Household” OR -

•checking the list of Factory Service Centers provided with this cleaner OR -

•calling 1-800-944-9200for an automated referral of authorized service outlet locations (U.S. only) OR -

•checking the Service section of The Hoover Company on-line at www.hoovercompany.co

Do not send your cleaner to The Hoover Company in North Canton for service, this will only result in delay.

If further assistance is needed, contact The Hoover Company Consumer Response Center, North Canton, Ohio 44720 Phone: 1-330-499-9499.

In Canada, contact Hoover Canada, Burlington, Ontario L7R 4A8, Phone: 1-800-263-6376.

Always identify your cleaner by the complete model number when requesting information or ordering parts. (The model number appears on the back of the cleaner handle.)

Cleaning carpeted stairs

Read “Before you begin cleaning” instructions on page 7.

Attach hose and solution tube as instructed on pages 9 and 10.

Fill clean solution tank according to instructions on pages 5 and 6. Use 5 ounces of HOOVER Carpet/Upholstery Detergent.

Hose length may require that machine be placed at the top of the stairs to clean upper half of stairway and at bottom of stairs to clean lower half.

To prevent machine from falling, use extra caution when cleaning on stairs. Do not place deep cleaner on stairs.

Do not point stair/upholstery nozzle at people or pets.

Dry hands and plug deep cleaner into a properly grounded outlet.

Turn deep cleaner ON.

Pre-spray the carpeted stair by holding the nozzle about one inch above the carpet and push the wand forward while pressing the solution trigger (equals one wet stroke).

Position nozzle against the riser and slightly press nozzle into carpet pile. Press the solution trigger and pull the nozzle slowly over the carpet (second wet stroke).

Release the trigger, lift nozzle, and position it against riser. Pull nozzle slowly over carpet without pressing trigger (dry stroke).

It is best to alternate wet and dry strokes as described above. End with more dry strokes to aid in faster drying of carpet.

Overlap strokes by one-half inch to help prevent streaking.

To avoid saturating carpet, do not use more than 4 wet strokes over any one area. Always end with dry strokes.

If additional cleaning is necessary, wait until the carpet is completely dry before using the nozzle again.

When finished cleaning, follow “After cleaning” instructions on page 8 and “After using stair/upholstery nozzle” instructions on pages 10-11.

11