Hoover Deep Cleaner Steam Vacuum Maintenance, Removable brushes, Cleaning upholstery, 3-21, 3-22

Cleaning upholstery

Read “Before you begin cleaning” instructions on page 9.

Be sure to check the cleaning code on your upholstery. Use your deep cleaner only on upholstery marked “W” or “W/S”.

1.Attach hose and solution tube as instructed in Figs. 3-10 to 3-12.

2.Place handle in upright position.

Agitator brushes will not rotate while handle is in upright position.

3.Fill clean water tank according to instructions for Figs. 2-9 to 2-12.

4.Fill detergent container with HOOVER Carpet/Upholstery Detergent according to instructions for Figs. 2-13 to 2-15.

5.Attach tool to end of hose.

Do not point tools toward people or pets.

6.Dry hands and plug deep cleaner into a properly grounded outlet.

7.Set Wash/Rinse switch to WASH. Turn cleaner ON.

3-21

8.Gently press the tool onto the fabric. Press the trigger and slowly pull the noz- zle over the fabric.

9.Overlap strokes by 1/2 inch to help prevent streaking.

Make additional strokes without pressing the trigger to remove more moisture.

10.To clean in corners or creases, lift the tool one-half inch from the fabric and press the solution trigger.

11.Vacuum up the solution with the tool without pressing the trigger.

12.For heavily soiled areas, it may be necessary to repeat the cleaning process. Make crisscrossing strokes to the original pattern; overlap each pass (Fig. 3-22).

3-22

Make no more than 2 passes with the solution or rinse over any one area to prevent over-wetting and damage to fabric.

If additional cleaning is necessary, wait until the upholstery is completely dry before using the tool again.

13.Empty recovery tank when the motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”, Fig. 2-6).

When finished cleaning, follow “After cleaning” instructions on pages 9 & 10 and “After using tool” instructions on page 12.

4. Maintenance

Removable brushes

Your deep cleaner is equipped with removable brushes for easy cleaning.

To remove brushes

Disconnect cleaner from electrical outlet.

To prevent possible leaking, remove clean water tank and recovery tank. Set tanks aside.

4-1

With handle in upright position, tilt cleaner back until handle rests on the floor.

4-2

Grab brush assembly and pull firmly.

The brushes can be cleaned under run- ning water.

4-3	B	D	B
	A
			A
	C

To replace brushes

Align posts (A) on both ends of brush assembly with slots (B) in cleaner hous- ing.

Make sure that the square post (C) also aligns with the square hole (D). Turn brushes slightly until post fits easily into hole.

Press brush assembly firmly to snap into place.

15