Dimplex DFB8842 Maintenance, Upper Light Bulb Requirements, Do not exceed 15 Watts per bulb

Maintenance

2.Remove four (4) Phillips screws from right side of trim (Figure 7).

3.Remove trim.

4.Slide glass to right side of fireplace to remove (Figure 7).

5.Pull the front edge of the plastic Log Set or plastic grate up and forward until the rear tab releases from the ledge located at the bottom of the mirror (Figure 8).

!IMPORTANT: Only handle the Log Set Assembly by the

Ember Bed or plastic grate.

!NOTE: Log Set Assembly fits tightly into firebox, some force may be necessary to remove.

Figure 8	Log
	Ember Bed
Back
Ledge

Rear
Tab		Front
	Side Section
		Edge

6.Set Log Set Assembly in front of fireplace.

7.Unscrew bulbs counter clockwise.

8.Insert new bulbs and screw in clockwise.

9.Install the Log Set Assembly by placing the front, bottom edge of the Ember Bed in the track behind the control panel. Once in place, push down on the back edge of the Ember

Bed until the rear tab snaps into place under the Mirror (Figure 8).

!NOTE: Ensure the Log Set

Assembly is installed tightly under the back ledge to prevent light leakage.

10.Slide front glass back into position and attach trim.

Upper Light Bulb Requirements

Quantity of two (2) clear chandelier or candelabra bulbs with an E-12 (small) socket base, 15 Watt rating.

Do not exceed 15 Watts per bulb.

To access the upper light bulb area:

1.Slide fireplace out of mantel.

2.Remove four (4) Phillips screws from right side of trim (Figure 7).

3.Remove trim.

16 www.dimplex.com