Hoover Deep Cleaner with Auto Rinse SteamVacuum Recovery tank, How to empty, Hoover detergent

2-11

Carry tank to a sink.

Turn tank cap counterclockwise and remove cap.

2-12

E

Fill tank (E) (1 gallon) with hot tap water.

CAUTION: Do not fill with water above 140°F (60°C).

Replace tank cap and tighten.

2-13

F

To fill detergent container (F), turn cap counterclockwise and remove cap.

2-14

Fill container (16 oz.) with HOOVER Carpet/Upholstery Detergent or HOOVER Bare Floor Cleaner.

Do not use Bare Floor Cleaner on carpet or upholstery. Do not use any type of wax with your ‘SteamVac’ deep cleaner.

To assure proper results, use only

HOOVER detergent.

Replace container cap and tighten.

NOTE: Use only HOOVER detergents.

They are specially formulated for use with your ‘SteamVac’ deep cleaner.

CAUTION: Detergents contain Anionic and Nonionic Surfactants. Avoid contact with eyes and skin. In case of contact with eyes, flush with cold water for 15 minutes. In case of contact with skin, wash with water. If irritation persists, call a physician. For Medical Information (U.S.) call 1-800-752-7869.

2-15

Position bottom of tank onto cleaner and pivot tank to snap it into place.

Recovery tank

(lower tank)

The recovery tank holds the dirty solu- tion that is picked up from the surface being cleaned.

When the recovery tank is full, the auto- matic shut-off will engage, suction will stop (see page 7), and the tank must be emptied.

How to empty

Turn deep cleaner off and unplug from electrical outlet.

To prevent possible leaking, remove clean water tank (Fig. 2-10) by pressing down on tank handle and pulling for- ward; set tank aside (do not set tank on furniture).

Step on handle release pedal (Fig. 2-3) and lower handle until it rests on the floor.

2-16	H
	G

Turn recovery tank latches (G) outward (one on each side of tank).

Raise handle (H) straight up and lift tank off cleaner.

Carry tank to sink or drain.

2-17

Lower handle toward back of tank to unlock lid. Lift lid off tank.

Empty tank and reposition lid.

For full suction, it is important that the recovery tank lid is properly secured before cleaning.

Raise tank handle to carrying position and place it onto deep cleaner. Lower handle to front of tank.

Turn latches (one on each side of tank) inward to lock tank in place.

Raise handle of deep cleaner to upright position and reposition upper clean

water tank. Continued ➜ 9