3-8

F

3.Remove recovery tank front panel (F) by sliding it straight up.

3-9

G

4.Replace panel with converter (G). Slide converter halfway down opening until it is firmly in place.

3-10

H

5.Before connecting tube (H) to cleaner, make sure black tabs are extended by pulling tan collar toward tube.

Open door on hood labeled “Stair/ upholstery Cleaning Connection”. Press round solution tube connector onto round projection inside door. Press con- nector collar down firmly to ensure that it is fully connected.

3-11

I

6.The tank replaces in a hinge-like manner. Position front of lid under tabs

(I) on front of tank. Rotate lid down onto tank.

Make sure lid is secure on all sides before cleaning.

For full suction, it is important that the recovery tank lid is properly secured before cleaning.

Reverse procedure to remove hose and solution tube.

Raise deep cleaner handle to upright

3-12

J

K

How to attach tool

All tools connect to the hose in the same manner.

1.Attach tool to connector end of hose by sliding it onto connector until the tab

(J) locks it securely.

Using your thumb, push forward and up on the latch (K) to remove tool as shown.

Before using tool

It may be necessary to remove air from the system (“prime the pump”) so the clean solution will flow to the tool. Follow these steps:

1.Attach tool to hose and turn the deep cleaner ON.

2.Put the tool on a hard surface or against your hand to block off the suc- tion.

3.Wait a few seconds (can take up to

15seconds). Then squeeze the trigger and begin cleaning.

Follow the instructions on pages 13 and 14 for the appropriate cleaning task.

position.

 

3-13

3-14

 

L

 

M

After using tool

1.Follow steps a and b for “After clean- ing” on pages 9 and 10.

2.Drain suction hose by turning deep cleaner ON and holding end of hose up for several seconds. Do not press trig- ger.

3.Disconnect deep cleaner from electri- cal outlet.

4.Drain solution tube by placing round end in sink and raising nozzle above your head. Press the trigger.

5.Proceed with steps c, d and e for “After cleaning” on pages 9 and 10.

Occasionally, debris may become lodged inside of the hose at the con- verter end (L). To clean out the hose, lift bottom of converter clip (M) with a screwdriver and remove clip. Remove debris as shown.

12

Page 11 Page 13
Page 12
Image 12
Hoover F5906900 owner manual How to attach tool, Before using tool, After using tool
Page 11 Page 13

F5906900 specifications

The Hoover F5906900 is a high-performance carpet cleaner designed to tackle tough stains and deep clean carpets in both residential and commercial settings. Engineered with advanced technology, this machine makes carpet cleaning an efficient and effective process.

One of the standout features of the F5906900 is its powerful suction capability. Equipped with a strong motor, it can extract dirt, debris, and pet hair from deep within carpet fibers. This ensures a thorough clean that leaves carpets looking fresh and revived. The cleaner's dual tank system further enhances its efficiency. It separates clean water and cleaning solution from the dirty water for a more hygienic cleaning experience. Users can easily refill the clean water tank, making it suitable for larger cleaning tasks without frequent interruptions.

The F5906900 also incorporates Hoover's SpinScrub Technology, which features multi-directional brushes that rotate to effectively lift and remove stubborn stains. This technology is particularly beneficial for high-traffic areas and homes with pets, where dirt and grime are more prevalent. These brushes gently scrub carpets without causing damage, making it safe for use on a variety of surfaces.

Another notable characteristic of the Hoover F5906900 is its lightweight design. Weighing in at just under 20 pounds, it is easy to maneuver around the house or office. The machine's low-profile foot allows it to reach under furniture and other hard-to-access spaces, ensuring a thorough clean throughout the room.

Furthermore, the cleaner is equipped with a quick-dry system that helps to accelerate the drying process after cleaning. This reduces the time carpets remain damp, allowing them to be used again in no time. The additional upholstery tool that comes with the F5906900 is perfect for cleaning surfaces such as stairs, furniture, and car interiors, making it a versatile choice for various cleaning tasks.

The Hoover F5906900 carpet cleaner is not only powerful but also user-friendly. Its straightforward controls and easy assembly mean that even those new to carpet cleaning can operate it with confidence. In conclusion, with its advanced technology, robust cleaning capabilities, and thoughtful design features, the Hoover F5906900 stands out as an excellent option for anyone looking to achieve a professional-grade clean in their carpets.
Top Page Image Contents