Hoover F5906900 owner manual Attach upper handle, Attach tool holder, Attach hose holder

The assembled cleaner will look like this drawing.

1-2

Attach upper handle

Remove clean solution tank (upper tank) from deep cleaner.

1-3

A

With cord hook (A) to back of deep cleaner, push upper handle down onto lower han- dle. Push bolts into holes on front of han- dle. If bolts will not go through hole easi- ly handle is not pushed completely down.

1-4

B

Attach hose holder

Position hose holder (B) onto handle by matching tabs on rack with openings on back of handle. Make sure bolts are through holes.

1-5

Place nuts in recessed areas on back of hose holder. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screwdriver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your conve- nience.

1-6

C

When handle sections are completely together, squeeze trigger (C) on upper handle to snap trigger rod in place.

1-7	1-8
	D
Attach tool holder	Slide holder down into place. Insert
Remove tool and taped screw from	screw at (D) and tighten with a Phillips
	screwdriver.
holder. Insert projections on holder into
slots on back of cleaner.

1-9

Replace clean solution tank (upper tank) by positioning bottom first. Press on tank handle to snap top of tank into place.

4