INSTALLATION
Installing a domestic appliance can be a complicated operation which, if not carried out correctly, can seriously affect consumer safety.
It is for this reason that the task should be undertaken by a professionally qualified person who will carry it out in accordance with the technical regulations in force.
In the event that this advice is ignored and the installation is carried out by an unqualified person, HOOVER declines all responsibility for any technical failure of the product whether or not it results in damage to goods or injury to individuals.
INSTALLATION: "BUILDING-IN"
Both the unit into which the hob will be fitted and any adjacent kitchen furniture must be made of heat resistant material and fixed with heat resistant adhesive.
If, when installing the hob, the lower part of the casing is adjacent to an area normally accessible when handling or cleaning, fit a heatproof partition 1 cm below the base of the casing, with a 10x10 cm opening in the rear
There should also be a 5 cm gap between the appliance and all adjacent vertical surfaces.
A foam adhesive seal is supplied with the hob. Stick this seal under the edge of the body as near as possible to the outer edge of the hob. Press round the edges of the hob, so that the seal flattens out and ensures an air tight seal.
Fitting the seal
Top view of the hob
SEAL
3
