INSTALLATION
(Technical notes)
■After unpacking, adjust the height of the dishwasher. For the dishwasher to work correctly it must be level. Adjust the feet so that the machine does not tilt by more than 2 degrees.
■If it you need to move the machine after removing the packaging, do not try to lift it by the bottom of the door. Follow the instructions in the figure. Open the door
slightly and lift the machine by holding on the top.
IMPORTANT
When the appliance is located on a carpet floor, attention must be paid to ensure that there is no obstruction to the bottom vents.
Make sure that the plug on the appliance remains accessible after installation.
Water connection
IMPORTANT
The appliance must be connected to the water mains using new
■The inlet and drain hoses can be directed to left or right.
IMPORTANT
The dishwasher can be connected to either cold or hot water, as long as it is no hotter than 60 °C.
■ Water | pressure must be between |
0,08 MPa and 0,8 MPa. If the pressure is | |
below the minimum consult our service | |
department for advice. | |
■ The inlet hose must be connected to a | |
tap so that the water supply can be cut | |
off when the machine is not in use | |
(fig. 1 | B). |
1
2
Electrical connection
Plug your dishwasher into the power socket.
If the plug we supply does not fit :
■CUT IT OFF AND DESTROY IT!
You can't use it on other appliances, and the exposed wires could be dangerous if anyone plugged it in.
■Fit a suitable plug, as follows:
Connect | to the terminal in the plug |
WARNING!
THIS APPLIANCE MUST BE EARTHED.
Fuses and plugs
This appliance should be used only on a socket with a minimum rating of 13 Amp.
Our
Any replacement should be exactly the same.
■ The dishwasher is fitted with 3/4" threaded |
connector (fig. 2). |
■ Connect inlet hose “A” to water tap “B” |
with a 3/4" attachment making sure that |
it has been properly tightened. |
■ If it is necessary, the inlet pipe can be |
lengthened up to 2,5 m. The extension |
pipe is available from the After Sales |
Service Centre. |
■ If limescale deposits or sand are present |
in the water, it is advisable to obtain the |
3
Green and
Marked with the letter E,
OR marked with the Earth symbol,
If the fuse cover is lost, do not use the plug until it is replaced.
A correct replacement fuse cover (obtainable from your dealer or Electricity board) must be
appropriate filter, art. 9226085, from the |
After Sales Service Centre (fig. 3). The |
filter “D” must be inserted between the tap |
“B” and the inlet hose “A” , remembering |
to fit the washer “C” . |
yellow wire OR coloured green,
OR coloured green and yellow.
the same colour as shown or named on the insert on the base of the plug.
Manufacturer declines all responsibility for any damage due to non-earthing of
■ If the dishwasher is connected to new |
pipes or to pipes which have not been in |
use for a long time run water through for |
a few minutes before connecting the |
Blue wire
Marked N,
OR coloured black.
the machine.
inlet hose. In this way no deposits of |
sand or rust will clog up the water inflow |
filter. |
Brown wire
Marked L,
OR coloured red.
This appliance complies with Directives 89/336/EEC, 73/23/EEC and following changes.
4 | 5 |