Replacing
rug/f
loor
nozzle
brush
When to replace
Replace the brush on the rug and
floor nozzle when it becomes
worn and is not doing a satisfac-
tory job of cleaning.
How to replace
Brush Lock Lever must be in
“RUG” position to remove brush.
I.
Remove one of the metal clips
holding brush in position by plac-
ing a screwdriver under the raised
edge and lifting upward. Note po-
sition of old brush and springs,
then remove them.
2. Screw springs onto projections
of new brush. Center new brush
in nozzle. Make sure that the
bristles are facing up and the pro-
jection side is turned toward the
tube.
Replace the clip and clamp into
position by pressing down with
the flat side of a screwdriver.