G
H
Identify the hose parts before storing hose.
G. Nozzle connector end H. Solution tube
Storing hose and tools
Press hose, a few inches from nozzle connector end, into caddy. Bring hose up and over top of caddy.
1 - 11
I
Press hose into opposite side of caddy. Loop hose at bottom of cleaner and press into top of hook (I).
1 - 12 | 1 - 13 | 1 - 14 |
K
J
K
Loop hose over top of caddy again.
Slide hose clip (J) toward end of hose.
Clip loose hose to hose in caddy. Press solution tube (K) into small clip on hose clip (inset).
Insert top of bare floor tool (available at | Snap stair/upholstery nozzle onto |
additional cost if not included with your | caddy. |
cleaner) through “loop” on caddy. Slide |
|
tool down into place. |
|
1 - 15
SpinScrub™ hand tool
(not included with all models)
The SpinScrub™ hand tool is shipped in a plastic bag for protection. To remove the bag before using the tool, open tool door.
1 - 16
Pull tool down and outward.
To reposition the tool, reverse this proce- dure.
1 - 17
How to reattach tool cover
The tool cover is designed with a break- away feature which allows it to snap free if it is pushed open too far.
To reattach, align hinges of cover with holes on sides of tool storage area. Snap door into place.
5
