Hoover SteamVacTM V2TM manual Attach upper handle, Attach hose/cord hook, Attach hose/tool caddy

The assembled cleaner will look like this	1-2	1-3
drawing. Model with SpinScrub™ hand			A

tool is shown.

Attach upper handle

Remove clean water tank (upper tank) from deep cleaner.

With cord hook (A) to back of deep cleaner, push upper handle down onto lower handle.

1-4 1 - 5 1-6

B

Push b o l t s into holes on front of handle. If bolts will not go through hole easily, han- dle is not pushed completely down.

Place nuts in recessed areas on back of the handle. Hold each nut in place while tightening each bolt securely (from the front of the handle) with a Phillips screw driver.

Only two nuts are needed on this model. The extra nut is not required but has been provided for your convenience.

Replace clean water tank (upper tank) by positioning bottom first. Press on tank handle (B) to snap top of tank into place.

Attach hose/cord hook

Insert tabs on hook into slots on back of cleaner. Snap hook onto cleaner.

Attach hose/tool caddy	1 - 7
The hose/tool caddy is designed to be
used either on the cleaner for easy
access to the tools and hose, or if the		C
tools are not going to be used, it can be
removed and hung for storage.
If you do not want to attach the caddy to
the cleaner at this time, proceed to Fig.
1-9 for proper hose placement on the		D
caddy.

1-8

F

E

Slide tabs (C) on caddy into slots (D) on back of cleaner.

Rotate top of caddy toward cleaner handle. Slide caddy down so notch (E) on caddy rests in hook (F) on cleaner.

4