Hoover Stick Cleaner owner manual Secondary filter, Lubrication, How to clean

3-4

D

D

3-5
B	C

3-6

Empty cup, making sure to hold cup with	Push filter (B) inside out through filter
dirt port (D) facing up.	frame.
Shake dust from filter.	For models with filter assembly, pivot
	cone (C) away from filter and push filter
	inside out through frame.

Brush the surface of filter to remove any clinging litter. (Filter or filter assembly may be washed in warm water. It must be completely dry before replacing in clean- er. Do not use cleaner without filter or filter assembly in place.)

3-7

C

3-8

E

F

3-9

Push filter back through frame and	Place filter on top of cup as shown and
pull it right side out.	push frame fully into cup.
For models with filter assembly, pivot	Tab (E) on the frame fits down into slot
cone (C) back into place.
	(F) in the cup.

Slide filter or filter assembly into cleaner body and latch cup into position.

3-10

G

Secondary filter

How to clean

Disconnect cleaner from electrical out- let.

The secondary filter (G) protects the motor from dirt particles and does not need to be removed for cleaning.

The filter is located on the inside top of the cleaner body and can seen when the dirt cup and filter are removed. When the filter becomes dirty, it can be cleaned by wiping it off with a damp cloth.

6

Rug and floor nozzle

To maintain the cleaning effectiveness of your deluxe nozzle or deluxe wheeled nozzle, the brushes may need to be replaced occasionally.

See your nearest Hoover Factory Service Center or Authorized Warranty Dealer (Depot) for new brushes.

Lubrication

The motor is equipped with two sleeve bearings. These bearings contain suffi- cient lubrication for the life of the motor.

Therefore, do not add lubricant to either motor bearing.