Hoover Turbo POWER Carpet Cleaner with Auto Rinse Cleaner manual To clean floor, Attach hose

To clean floor

Read “Before you begin cleaning” instructions on page 10.

Do not use the carpet cleaner on unsealed hardwood floors.

1.Fill clean water tank according to instructions for Figs. 2-9 to 2-11.

2.Fill detergent container with HOOVER Hard Floor Cleaning Solution according to instructions for Figs. 2-12 to 2-14.

3.Set SpinScrub mode selector to

GENTLE SCRUB.

4.Dry hands and plug carpet cleaner into a properly grounded outlet.

5.Step on handle release pedal and lower handle to operating position.

6.Set Rinse Setting switch to WASH- AutoRinse. Turn cleaner ON.

7.To release solution, press trigger. Slowly move carpet cleaner forward and backward over area to be cleaned. Water and detergent will be released on the forward stroke. A water-only rinse will automatically be released on the reverse stroke.

8.To pick up dirty solution, release trig- ger and slowly move carpet cleaner over area where solution has just been dispersed. Use both forward and reverse strokes.

9.If rinsing the floor is desired, set Rinse Setting switch to RINSE. Repeat steps 7 & 8. This setting provides a water-only rinse in both the forward and reverse strokes.

Rinsing is not necessary, but will help remove detergent residue from the floor.

10.Empty recovery tank when the

motor sound becomes higher pitched and there is a loss in suction (see “Automatic shut-off”, Fig. 2-6).

11.When finished cleaning, follow “After cleaning” instructions on page 11.

Unplug carpet cleaner from electrical outlet and remove attachment from noz- zle. Rinse it in clear water. Do not remove plastic screen or foam from attachment.

Using the tools

Attach hose

Unplug cleaner from electrical outlet.

3-11

E

Open hose connection port (E).

3-12

Insert short hose end, matching tabs on hose with same-sized slots in port. Push hose into port and lock in place.

3-13

F

Plug solution tube firmly into solution connection port (F).

3-14

G

To remove hose: Squeeze latches (G) on top and bottom of hose. Remove hose from port. Close door.

Remove solution tube from solution con- nection port.

Select tool

Your model includes some combination of the following tools, but may not

include them all.

3-15

I

H

J

H. SpinScrub™ hand tool has rotating brushes for extra scrubbing action on small carpet areas, carpeted stairs and upholstery.

I. Stair/upholstery nozzle has a built-in brush to help provide the scrubbing action some spots may need for removal.

J. Crevice tool can be used to clean along edges of carpet, carpeted stairs and on upholstery.

How to attach tools

3-16

K

L

Unplug carpet cleaner from electrical outlet.

1.Place handle in upright position and remove hose from rack.

All tools attach to the hose in the same manner:

2.Connect tool to hose by sliding it onto connector until the tab (K) locks it securely.

Using your thumb, push forward and up on the latch (L) to remove tool.

Continued ➜ 13