The headlight
How to replace the headlight
Disconnect cleaner from electri- cal outlet.
This cleaner uses 12 volt, wedge base type 912 bulbs.
1.Set adjustment lever for pile height to the “NORMAL” or “HIGH” position.
2.Turn cleaner over and remove the two screws indicated in the il- lustration. Place cleaner in the upright position and remove hood.
3.Remove bulb by pulling straight out of socket. Replace by pushing bulb straight into socket until it locks in place.
4.Replace hood and screws. Tighten screws securely.
The belt
The belt of your cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bot- tom plate of the cleaner and should be checked from time to time to be sure it is in good condition.
When to replace the belt
To check the belt, remove the bottom plate (see following section). If the belt is stretched, cut or broken, replace the belt.
What belt to buy
To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt ask for HOOVER part No. 49258.
17
