Toshiba RAS-10SAVP-E How to Set the Auto Restart Function, 50, When the unit is in operation

9-3. Auto Restart Function

This indoor unit is equipped with an automatic restarting function which allows the unit to restart operating with the set operating conditions in the event of a power supply being accidentally shut down.

The operation will resume without warning three minutes after power is restored.

This function is not set to work when shipped from the factory. Therefore it is necessary to set it to work.

9-3-1. How to Set the Auto Restart Function

To set the auto restart function, proceed as follows:

The power supply to the unit must be on ; the function will not set if the power is off.

Push the [RESET] button located in the center of the front panel continuously for three seconds.

The unit receives the signal and beeps three times.

The unit then restarts operating automatically in the event of power supply being accidentally shut down.

• When the unit is standby (Not operating)

Operation			Motions
Push [RESET] button for more than	The unit is on standby.
three seconds. (Less than 10 seconds)	↓
	The unit starts to operate.		The green indicator is on.
	↓	After approx. three seconds,
	The unit beeps three times		The green indicator flashes
	and continues to operate.		for 5 seconds.
RESET	If the unit is not required to operate at this time, push [RESET]
FILTER TIMER PURE OPERATION
	button once more or use the remote controller to turn it off.

• When the unit is in operation

Operation			Motions
Push [RESET] button for more than	The unit is in operation.		The green indicator is on.
three seconds. (Less than 10 seconds)	↓
	The unit stops operating.		The green indicator is turned off.
	↓	After approx. three seconds,
	The unit beeps three times.		The green indicator flashes
			for 5 seconds.
RESET	If the unit is required to operate at this time, push [RESET] button
FILTER TIMER PURE OPERATION	once more or use the remote controller to turn it on.

•After restarting the air conditioner by the AUTO RESTART OPERATION, the louver swing (AUTO) operation resumes.

•While the filter check indicator is on, the RESET button has the function of filter reset button.

– 50 –