Toshiba RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-10SAVP-E service manual 94

No.	Part name		Procedures				Remarks
†	Bearing	1)	Follow to the procedure in the items •.
		2)	Remove the two fixing screws used to secure
			the left edge panel of the heat exchanger, and
				Screw
			remove the two screws used to secure the
			bearing base.		Bearing
					base
						Screw

3) Raise the left side of the heat exchanger
slightly, and remove the bearing base.	Raise the left side

<Caution at assembling>

•If the bearing is out from the housing, push it into the specified position and then incorporate it in the main body.

• After assembling the bearing base, check that it
is fitted into the stepped part of the drain pipe.
		Remove in this direction
	Bearing base
			Bearing

Drain pipe

Drain pipe

Bearing base

– 94 –