Toshiba RAS-B13SKVP-E No. Part name, Procedures, Remarks, ˆCross flow fan Caution at reassembling

No. Part name Procedures Remarks

ˆCross flow fan <Caution at reassembling>

1)At assembling work of the bearing base, check that the drain pipe is surely incorpo- rated in the back body.

(Otherwise, water leak is caused.)

2)To incorporate the fan motor, remove the fan motor rubber (at shaft core side), incorporate the motor into the position in the following figure, and then install the fan motor.

Bearing base

Drain pipe

• Install the cross flow fan so that the right
end of the 1st joint from the right of the
cross flow fan is set keeping 70.5 mm from
wall of rear plate of the main unit.
• Holding the set screw, install the cross flow	Joint
fan so that U-groove of the fan motor
comes to the mounting hole of the set
screw.

70.5mm

•Perform positioning of the fan motor as follows:

•When assembling the fan motor, the fan motor must be installed in such a way that the fan motor leads will be taken out is positioned at the bottom front.

•After assembling the two hooking claws of the motor band (right) into the main body, position the fan motor, insert it, and then secure the motor band (right) using the two fixing screws.

U groove

– 96 –