Toshiba RAS-B10SKVP-E J201, Item, Operation flow and applicable data, etc, Description

Item		Operation flow and applicable data, etc.	Description
16. Clean operation	Setting the clean operation cancel		NOTE:
cancel			Once J201 is added, the [RESET]
		Add J201 of the indoor P.C. board assembly.	button on the unit is designated for
			CLEAN OPERATION (Set/Cancel),
		* This cancels the auto restart function.
			therefore the [RESET] button can
			not be used for the selection (Set/
			Cancel) of AUTO RESTART
		Hold down the [RESET] button on the indoor unit	function (Page 50).
		for at least 3 seconds but not more than 10 seconds.
			* J201 will be near the MCU so
			take steps to ensure that it will
			not be exposed to excessive of
		The indoor unit’s buzzer emits three beeps.
			heat.
			Also take care to avoid solder
			bridging with the surrounding
			components.

This completes the clean operation cancel setting.

Setting the clean operation

Hold down the [RESET] button on the indoor unit for at least 3 seconds but not more than 10 seconds.

The indoor unit’s buzzer emits three beeps, and the OPERATION indicator flashes at 5 Hz intervals.

This completes the clean operation setting.

Indoor P.C. board

J201

C24

– 43 –