Toshiba RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-10SAVP-E Installation Procedure, Safety Cautions

10. INSTALLATION PROCEDURE

10-1. Safety Cautions

For the rear left and left piping

140 mm or more

Hook 47 mm or more

1 Installation plate

Hook

74 mm or more

Hook

Wall

Insert the cushion between the indoor unit and wall, and tilt the indoor unit for better installation work.

Air filters

2 Wireless remote controller

5 Plasma pure filter

80 mm or more only
when unobstructed to	Y
the front and both sides

6 Mounting screw

ZShield pipe (for extension drain hose)

Do not allow the drain hose to become slack.

Cut the piping hole slightly sloped

Make sure the drain hose is sloped downward.

The auxiliary piping can be connected at the left, rear left, rear right, right, bottom right or bottom left as shown below.

Right

100 mm or more from wall

(C)

4 Remote controller holder

50 mm or more

In principle, from wall leave open

(D)

Rear	Bottom
right		Left
	left
Bottom right		Rear left

200 mm or more

(B)

7 Remote controller holder mounting screw

When installing the outdoor unit, leave open in at least two of directions (A), (B), (C) and (D) shown in the figure below.

Ensure sufficient space to allow drainage

(A)

250 mm or more from wall

Power cord

Extension drain hose (Option: RB-821SW)

As shown in the figure, position power cord and connecting cable downward, and lead out along piping connection port.

Insulate the refrigerant pipes separately, not together.

Before installing the wireless remote controller

6 mm thick heat resisting polyethylene foam

• With the remote controller cover removed, correctly load the supplied batteries while observing their polarity.

2 Wireless remote controller

Cover

3 Batteries

•Indoor units connectable with a multi-system outdoor unit (Other indoor units are unavailable.) RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-B16SKVP-E

•When using a multi-system outdoor unit, refer to the installation manual provided with the model concerned.

– 55 –