Toshiba RAS-B10SKVP-E, RAS-B13SKVP-E, RAS-10SAVP-E 106, Procedure, Remarks, Parts name

No. Part name

15Replacement of temperature sensor for servicing only

Common service parts of sensor TO, TS, TE, TD

Procedure

1)Cut the sensor 100 mm longer than old one.

2)Cut the protective tube after pulling out it (200 mm).

3)Move the protective tube toward the thermal sensor side and tear the tip of lead wire in two then strip the covering part.

4)Pass the stripped part through the thermal constringent tube.

5)Cut the old sensor 100 mm length on the connector side, and recycle that connec- tor.

6)Tear the lead wire in two on the connector side and strip the covering part.

7)Twist the leads on the connector and sensor sides, and solder them.

8)Move the thermal constringent tubes toward the soldered parts and heat them with the dryer and constring them.

9)Wind the attached color tape round the both terminals of the protective tube when colored protective tube is used.

10)Fix the sensor again.

NOTE

Remarks

Thermal	Cutting here
	Connector	100
sensor part

200Cutting here

		15
Thermal		70
constringent tube
Cutting here
	100
15	Soldered part
70

Dryer

Winding the color tape

These are parts for servicing sensors.

Please check that the accessories shown in the right table are packed.

1)Store the joint part of the sensor and the connector in the electric parts box.

2)Never joint them near the thermal sensor part.

Otherwise it would cause insulation inferiority because of dew drops.

3)When replacing the sensor using the colored protective tube, wind the color tape matching the color of that tube.

	Parts name	Q'ty	Remarks
1	Sensor	1	Length : 3m
2	Sensor Spring (A)	1	For spare
3	Sensor Spring (B)	1	For spare
4	Thermal constringent tube	3	Including one spare
5	Color tape	1	9 colors
6	Terminal	3

16Cord heater assembly

(-ND model only)

1)Perform the procedures in ‡ above. (Do not perform the procedure in ‡-6).)

2)Remove the cord clamp. (ST1Tø4 x 10L 1 pc.)

3)Remove the cord clamps (12 locations) fixing the cord heater assembly to the base plate.

4)Attach the new cord heater assembly to the base plate using the cord clamps supplied with the cord heater assembly. (Service code: 37557729)

Cord heater assembly

– 106 –