Toshiba RAS-10SAVP-E Item, Operation flow and applicable data, etc, Description, Fig, Indication

		Item				Operation flow and applicable data, etc.					Description
2. Indoor fan				<In heating operation>							1) When setting the fan speed to L,
	motor control										L+, M, M+ or H on the remote
											controller, the operation is per-
											formed with the constant speed
		HEAT ON
											shown in Fig. 3 and Table 1.
											2) When setting the fan speed to
		Fan speed setup									AUTO on the remote controller,
							MANUAL
											revolution of the fan motor is
										(Fig. 3)	controlled to the fan speed level
											shown in Fig. 5 according to the set
							Indication			Fan speed	temperature and room temperature.
							L			W8	3) Min air flow rate is controlled by
							L+			(L + M) / 2	temperature of the indoor heat
		AUTO									exchanger (Tc) as shown in Fig. 4.
							M			WA
											4) Cold draft prevention, the fan speed
							M+			(M + H) / 2
											is controlled by temperature of the
							H			WE	indoor heat exchanger (Tc) as
											shown in Fig. 6.
		TC ￿	42˚C			YES
								Min air flow rate control
		NO
							Tc		Limited to Min WD tap
							52
							51
							42		*
							41
									No limit
							* Fan speed =
							(TC – (42 + a)) / 10 x (WD – W8) + W8
					(Fig. 4)		a : In up operation 1, in down operation 0				Cold draft preventive control

TA [˚C]

TSC

–0.5

–1.0

–1.5

–2.0

–2.5

–5.0

–5.5

Basic fan control

b

c

d

e

f

g

Fan speed

AUTO

L+ (W9)

*1

*2

*3

M+ (WD)

H (WE)

	Tc
46	46	34
45	45	33
33	33	21
32	32	20
*A+4	*A+4	*A+4
*A-4	*A-4	*A-4

H (WE)

Line-approximate

H and SUL with Tc.

SUL (W2)

Stop

Fan speed MANUAL in starting Fan speed AUTO in stability Fan speed AUTO in starting

*1: Fan speed = (M + –L+) x 1	4	+ L
*2: Fan speed = (M + –L+) x 2	4	+ L
*3: Fan speed = (M + –L+) x 3 ￿4		+ L

(Calculated with linear approximation from M+ and L)

*No limitation while fan speed MANUAL mode is in stability.

*A: When Tsc ￿24, A is 24, and when Tsc < 24, A is Tsc

Tsc: Set value

		(Fig. 5)		(Fig. 6)
[In starting and in stability]
		In starting		In stability
	• Until 12 minutes passed after operation start		• When 12 to 25 minutes passed after operation start
FAN AUTO	• When 12 to 25 minutes passed after operation		and room temp. is higher than (set temp. –3°C)
	start and room temp. is 3°C or lower than set temp.		• When 25 minutes or more passed after operation start
FAN Manual	• Room temp. < Set temp. –4°C		• Room temp. ≥ Set temp. –3.5°C

– 32 –