Check agitator shield
Because your cleaner picks up so well, we strongly recommend you check for debris accumulation under the agitator shield each time you clean the filters.
Headlight replacement (some models only)
What to buy
This cleaner uses a 12 volt, wedge base type 912 bulb, Hoover part No. 27313101.
Removing debris under the shield will help maintain your cleaner’s excellent pick up and suction. Remove debris as follows:
1.Disconnect cleaner from electrical outlet.
2.Check for dirt accumulation by removing bottom plate (Fig.
3.Remove any debris and replace shield, agitator and bottom plate (Figs.
Removing lens
Disconnect cleaner from electrical outlet.
Using a screwdriver, remove the two screws as shown and lift off lens.
Installing bulb
Pull old bulb straight out of socket. Push new bulb straight into socket until locked in place.
Excessive force is not required.
Replacing lens
Reposition lens and secure with the two screws.
Belt replacement
The belt on your Hoover cleaner causes the agitator to rotate and is important for the effective operation of the cleaner. The belt is located under the bottom plate of the clean- er and should be checked from time to time to be sure it is in good con- dition.
When to replace
Disconnect cleaner from electrical outlet.
To check belt, remove bottom plate as shown in “How to replace”. Replace belt if it is stretched, cut or broken.
What to buy
To assure effective operation, use only genuine HOOVER belts with your cleaner. When purchasing a new belt, ask for HOOVER part No. 38528033 (belt package part No. 40201160).
A |
How to replace
Disconnect cleaner from electrical outlet.
Removing bottom plate
Place handle in low position and turn cleaner over so bottom side is up.
Remove the 4 screws as shown with a Phillips screwdriver.
Lift off bottom plate (A).
B |
B |
D |
C |
E |
D |
Removing agitator brush roll
Remove agitator brush roll and used belt.
Discard used belt.
10
Installing new belt
With lettering on outside of belt and positioned as shown in box on (D), slide new belt over motor pulley (B).
Replacing agitator brush roll
Insert agitator through belt and place belt in belt guide (C) on agitator.
Should the agitator shield (D) become dislodged while replacing the belt or the agitator, reposition it as shown noting the placement of its belt guide (E).
