Hoover UH70600 Powered hand tool, Agitator brush roll replacement, 3-19, 3-20, 3-21, 3-22, 3-23

Powered hand tool

Agitator brush roll replacement

When agitator brush roll brushes are worn, the brush roll should be replaced. Ask for HOOVER part No. 48414088.

3-19

A

How to replace

1.Remove tool from hose and turn it so bottom faces up. Press the latches on either side of tool and remove bottom plate (A).

3-20 B

2.Unscrew the two Phillips screws and remove belt guard (B).

3-21

C

D

C

3.Remove agitator including end plates

(C) and discard.

4.Inspect belt to ensure that it is in good condition. If belt is cracked, gouged or broken, replace it (see follow- ing section).

5.Insert brush roll through belt and posi- tion belt over gear teeth (D) on brush roll.

3-22
C	E

6.With curved ends down, slide end plates (C) of brush roll into slots (E) on tool.

3-23

B

7.Replace belt guard (B) making sure not to pinch brush bristles in guard. Turn agitator, making sure it rotates freely.

Replace and tighten screws.

3-24

A

8.To replace bottom plate (A), insert the four tabs on edge of bottom plate into slots on front of tool.

Pivot bottom plate down and snap closed.

Powered hand tool

Belt replacement

The powered hand tool belt is designed to last a long time and is not normally replaced. However, if the belt is crack- ed, gouged or broken, it should be replaced.

3-25

The belt can be seen through the top of the nozzle or by removing the bottom plate and belt guard (Figs. 3-19 and 3-20.

Replacing belt

When replacing belt, ask for HOOVER

part No. 38528037.

1.Remove bottom plate, belt guard and brush roll as described in Figs. 3-19 through 3-21.

3-26	F
	E

2.Grasp turbine (E) and pull firmly to remove.

3.Remove belt from turbine pulley (F). Replace with new belt.

3-27

H

G

4.With flat sides of turbine retainers (G) pointing down, slide retainers into grooves (H) in tool housing and snap into place.

5.Replace brush roll, belt guard, and bottom plate as described in Figs. 3-21 through 3-24.

12