7. START UP
WARNING
1.All parts are
2.If the unit is turned off, wait for at least 3 minutes before restarting the ice dispenser to prevent damage to the Compressor.
1)Clean the Storage Bin.
2)Open the Water Supply Line
3)Plug in and move the Power Switch, located on the left bottom of the Middle Front Frame, to the “ON” position.
4)Move the Ice Making Switch, located on the Control Box, to the “ICE” position.
5)Check that water flows into the Reservoir and the Freezer Assembly:
•Water flows into the Reservoir through the Water Valve.
•Water flows into the Freezer bottom through the Feeder Tubing.
•The Float Switch trips to close the Water Valve.
6)Check the water supply and drain connections for water leaks.
7)After the Water Valve closed, the Gear Motor starts first, and then the Compressor starts in approximately 60 sec. An automatic and continuous icemaking process starts.
8)In a few minutes, cubelet ice is extruded into the Storage Bin.
9)Check if there is any abnormal noise from the Compressor, the Fan Motor or the Gear Motor after 30 minutes of running.
10)Activate the Sensor labeled “ICE” and the Solenoid Shutter Valve opens to dispense ice.
12
