warp and cause some space between its center and the showcase bottom. In this case, provide a support to keep the foundation level.
* Avoid a site where dripping is not allowed.
No good | Good |
Support
Fig. 3
*Do not expose the showcase to direct sunlight or higher temperatures to prevent damage to the plastic housing. Adding additional heat will also affect showcase operating temperatures. Assure that there is no heat producing equipment located near the case, no heating vents blowing on the case, or high wattage lamps shining on the case.
*Allow at least 6” (15cm) clearance between the condenser air inlet/outlet and the wall or other equipment for proper air circulation. The rear of the showcase should have enough space for smooth operation of the power switch and for easy access to the louver and air
Air Inlet
Air Outlet
6”6”
Fig. 4
3. SET UP
IMPORTANT
Carry the showcase by holding its bottom.
1)Unpack the showcase, and remove all shipping carton, evaporator spacer, tapes and packing BEFORE operating the unit. Be careful not to damage the exterior panels when handling the showcase.
3
