Hotpoint 25 Plug in the Refrigerator, Start the Icemaker, Important Notes, Tools YOU will Need

Installation Instructions

INSTALLING THE WATER LINE (CONT.)

11PLUG IN THE REFRIGERATOR

Arrange the coil of tubing so that it does not vibrate against the back of the refrigerator or against the wall. Push the refrigerator back to the wall.

START THE ICEMAKER

Power switch models – Set the icemaker power switch to the I (on) position. The icemaker will not begin to operate until it reaches its operating temperature of 15°F (–9°C) or below. It will then begin operation automatically if the icemaker power switch is in the I (on) position, and the green light will come on.

Power

SwitchIcemaker

START THE ICEMAKER (CONT.)

Feeler arm models – Move the feeler arm to the ON (down) position. The icemaker will not begin to operate until it reaches its operating temperature of (15 F) (-9 C) or below. It will begin operation automatically if the icemaker feeler arm is in the ON (down) position.

Feeler Arm in the

STOP (up) position

Feeler Arm in the ON (down) position

Feeler arm model

NOTE: In lower water pressure conditions, the water valve may turn on up to 3 times to deliver enough water to the icemaker.

Green Power	Feeler Arm
Light

Power switch model

REVERSING THE DOOR SWING

IMPORTANT NOTES

When reversing the door swing:

•Read the instructions all the way through before starting.

•Handle parts carefully to avoid scratching paint.

•Set screws down by their related parts to avoid using them in the wrong places.

•Provide a non-scratching work surface for the doors.

IMPORTANT: Once you begin, do not move the cabinet until door-swing reversal is completed.

These instructions are for changing the hinges from

the right side to the left side—if you ever want to change the hinges back to the right side, follow these same instructions and reverse all references to left and right.

Unplug the refrigerator from its electrical outlet.

Empty all door shelves, including the dairy compartment.

TOOLS YOU WILL NEED

Phillips screwdriver

5/16″ Head socket driver 3/4″ Head socket driver (a 6-point socket is recommended)

Putty knife or thin-blade screwdriver

Masking tape

16