D ISHWASHER
How to use your Dishwasher
First of all.
-Turn on the water supply tap completely.
-Add the correct amount of detergent.
-Load the baskets correctly.
-Check that the spray arms rotate freely.
-Close the door securely.
Select the wash cycle. Select the wash cycle by pressing button "P". Each time this button is pressed, one of the indicator lights "M" will come on in sequence, se- lect the wash cycle most suitable for the type of dishes to wash (see ‘Programme Chart’).
Close the door and after a few sec- onds, you will hear a short beep: the wash cycle has begun.
Modifying a wash cycle in progress.
Ifyouhavechosenthewrongcycle
-You can modify the wash cycle in progress, if it has only just started. Open the appliance door carefully to avoid any hot water splashes, then keep button "P" pressed for approximately 5 seconds, until you hear 3 short beeps. Indicator light "M" will come off and at this point, all the settings will have been can- celled. You are now free to
You've left out a dish? Interruptthewashcyclebyopening the appliance door with the utmost care, as usual, then insert the dish you had forgotten. When you shut the appliance door, the cycle will start up from where you interrupted it.
Cycle end
The end of the wash cycle is indi- catedbyadoublebeepandtheflash- ing of the wash cycle indicator light "M".
Open the dishwasher door, press the
Wait a few minutes before unload- ing the dishes: they are very hot! If youwaitalittlewhile,theydrybetter due to the steam.
Empty the lower rack first.
There's been a power failure or you opened the dishwasher door
The wash cycle stops and then restarts when the electricity comes backonorwhenyouclosethedoor.
7