Hotpoint BS 1400 manual Personalisations, Setting the spin cycle, Setting the temperature

Personalisations

Option buttons

Setting the spin cycle

If, when the appliance is switched on, the KNOB is positioned on a programme with a spin cycle, a fixed appears. Press button and the maximum spin speed allowed for the

programme set will be displayed, and the icon flashes. Press it again and the values lower until they reach OFF, which indicates that the spin cycle has been excluded (press it again to go back to the maximum value); stop on the desired speed, after approximately 2 seconds the setting is accepted: the

symbol remains fixed. The spin cycle setting is enabled with all the programmes except for J and the Draining cycle.

GB

Installation

Setting the temperature

If, when the appliance is switched on, the KNOB is positioned on a programme for which the temperature

needs to be regulated, a fixed appears. Press button and the maximum temperature allowed for the

programme set will be displayed and the icon flashes. Press it again and the temperature lowers until it reaches OFF, which indicates a cold wash cycle (press it again to go back to the maximum value); stop on

the desired value, after approximately 2 seconds the setting is accepted: the symbol remains fixed. The temperature adjustment is enabled with all wash programmes.

Setting the Delay Start

Press the button and you will see the word OFF on the display, while the relative symbol flashes.

Press the button again and "1h" appears, that is, a delay of one hour (this can reach up to 24h); stop on the "desired" delay; after approximately 2 seconds the setting is accepted, following which, the time for the

set programme appears on the display and the symbol remains on.

If you now press the START/CANCEL button, the set "delay" appears; this decreases every hour until the start of the cycle. In this phase, the "delay" can only be modified by decreasing it.

The Delay Start regulation is enabled with all programmes.

For safety reasons (for example: preventing children from climbing into the drum and locking themselves in), if the door is opened or closed before the effective start of the cycle, it will be necessary to press the START/CANCEL button again.

Keyboard Lock￿(see page 7).

Functions

To enable a function:

1.press the button corresponding to the desired function, according to the table below;

2.the function is enabled when the corresponding button is illuminated.

Note: The rapid flashing of the button indicates that the corresponding function cannot be selected for the programme set. If you set a function that is incompatible with another function you selected previously, only the last one selected will be enabled.

Function	Effect	Comments		Enabled with
				programmes:
	Allows for an impeccable
	wash, visibly whiter than a			A, B, C, D, E, F, K
Super	standard Class A wash.
Wash
	Reduces water and	Use this function when the laundry that needs to be		A, B, C, D, E, F, H,
		washed is equal to or less than half the recommended
	energy consumption and			K, L, M, Rinse
		max. load (see Programme table).
Mini	wash cycle times.			cycle.
		Reduce the amount of detergent accordingly.
Load
		If you set this option, programmes E, F, J, L, M will be
	This option reduces the	suspended, leaving the laundry to soak (Anti-crease)
		and EASY IRON button will flash:
	amount of creasing on			C, D, E, F, J, K, L, M,
		- to conclude the cycle, press the START/CANCEL
	fabrics, making them			Rinse cycle.
		button or the EASY IRON button;
	easier to iron.
Easy		- to run the draining cycle alone, set the knob to the
Iron		relative symbol	and press the START/CANCEL button.

Description Programmes Detergents Precautions

Care Troubleshooting Service

9