Hotpoint CSX24X warranty How to Set the Door Alarm, How the Solid State Monitor System Work

How to Set the

Door Alarm

You don’t have to set the visual alarm. As long as either door is open. the red DOOR OPEN signal light flashes.

If the green signal light on the

DOOR ALARM pad is glowing, the beeper alarm is set. If it’s not, touch the pad to turn it on.

If either door is open for more than 30 seconds;, a recurring beep sounds.

The light goes out and the beeping stops when you close the door.

There are times when you’ll want the Door Alarm beeper turned

off. When you’re rearranging a lot of food, for example. Just touch the pad. The green light will go out and the beeping will stop.

Deactivating the Door Alarm beeper does not turn the red DOOR OPEN light oft-it keeps flashing until the door is closed.

Why the Red Warm Temperature Light G1OWS

At first, it’s probably because your newly installed refrigerator hasn’t completely cooled down yet. Wait a few’ hours for it to coo], and then the I ight will go out.

From then on, the red light will glow whenever temperatures inside get too high for proper food stor~.ge. If this happens, open the doors only when absolutely necessary, and close them as quickly as possible.

As soon as inside temperatures return to normal, the I ight goes out.

How the Solid State Monitor System Work

The word NORMAL is lighted in green except when a failure has been detected.

The STATUS CHECK-RESET pad has two functions:

1. You can touch the STATUS CHECK-RESET pad and get a review of the electronic diagnostic codes in order of their priority.

2.You can touch the STATUS CHECK-RESET pad to erase three flashing codes immediately. Two codes (DE and FF) cannot be erased until the condition that caused them to flash has been corrected (see page 8).

(continued next page)

7