Hotpoint CSX24X warranty To Remove Dmwers

Models: CSX24X

1 24
Download 24 pages 2.28 Kb
Page 16
Image 16
To Remove Dmwers

To Remove Dmwers

1.Remove food from the shelf above the Sealed & Fresh drawer and take out the shelf. Take food off the glass cover and out of the drawer.

2.Put your fingers behind the gasket at the rear of the drawer and pull forward. Remove the gasket.

3.Pull the drawer partway out. Reach in, push the rear of the glass up; at the same time, push it back

until it clears front-corner retainers.

4.Tilt and remove the cover.

\l

Ill,

,, -,

5.Pull the drawer forward, lift the front to clear stops, and remove the drawer. Ifthc refrigerator door doesn’t open completely. pull the drawer out until it hits the door. Then lift the drawer up until it is higher than the drawer supports. tilt it and take it out.

6.If tape holds Convertible Meat

Pdn cover to drawer supports, remove the tape. Pull drawer partway out. Reach in, push the rear of the glass up and, at the same time, back, until

it clears front-corner” retainers.

,

8. Tilt and rcmove the drawer.

After clean ing, replace in reverse order.

When drawers and covers are back in place. reinstall the gasket at the rear of the Sealed & Fresh drawer. Fit the end of the plastic drawer support into the slot on the gasket, with the rubber gasket fl:Ip facing you. Make sure the gasket snaps into place.

L

II 1 I

7. Tilt and remove the cover.

10

Page 16
Image 16
Hotpoint CSX24X warranty To Remove Dmwers