Installation
CONVERSION FOR USE ON BUTANE GB OR PROPANE
Each hob burner requires the injector to be replaced and each burner gas tap to have the
1.Lift off the burner cap and the burner body and place it to one side.
2.Remove the injector from the burner base with a suitable box spanner and discard.
3.Replace the injector with the appropriate replacement (see Table on the previus page).
4.Repeat for each burner.
5.Replace the burner bodies and caps, taking care that they are positioned correctly.
6.Remove the tap knob from the left hand hotplate tap. Insert a narrow flat screwdriver centre of the tap spindle and turn fully clockwise. Replace the tap knob. Repeat this procedure with the other six hotplate taps.
7.Position and fix the
SPACE FOR FIXING
The cooker can be close fitted below hotplate level. This requires a minimum distance of 1000mm between cupboard units of hotplate height.
When installing next to a tall cupboard, partition or wall, for a minimum distance of 400mm above hotplate level, allow a side clearance of at least 65mm.
The diagram below illustrates the minimum clearance between the cooker and adjacent walls, cupboards etc.
The wall behind the cooker between the hotplate and 450mm above, and the width of the cooker, must be
a
If the cooker is to be fitted close to a corner on the left hand side, ensure that there is a clearance of at least 50mm to allow the main oven door to open fully for when removing oven shelves.
750mm min
COOKER HOODS
If a cooker hood is to be installed, refer to the cooker hood manufacturers' instructions regarding fixing height.
UNPACKING THE COOKER
Unpack the components from inside the grill and oven. Check that the following parts are present:
Meat pan | Pan supports |
Grill pan, grid and handle | LPG conversion kit |
Hotplate burners parts | Oven & Grill shelves |
Griddle (EG1000GX only) | Literature pack |
After unpacking your cooker, make sure that you remove all the packing from the oven and grill, and any stickers from the oven door and the hob.
LEVELLING
Your cooker is heavy, so it would be advisable for two people to move it. The cooker is fitted with rear wheels and will slide into position easily. Movement of your cooker is most easily achieved as follows.
Open the grill/oven door sufficiently to allow a comfortable grip on the underside front edge of the oven roof, avoiding any grill or oven interior furniture, and then lift and slide back at the same time.
Your cooker must stand on a flat surface so that the hob is perfectly level, and the cooker is stable and cannot be rocked, this is easily achieved by adjusting the three feet which are under the front of the cooker and the 3 castors under the rear of the cooker, if necessary.
24
