ELECTRICAL CONNECTION
Those ovens equipped with a
WARNING: THIS APPLIANCE MUST BE EARTHED. The wire for earthing the appliance is
The appliance should be installed by a qualified electrician in accordance with the latest edition if the IEE regulations.
Fitting on a power supply cable
Opening the terminal board:
•Using a screwdriver, press on the side tabs on each side of the terminal board cover.
•Pull open the cover of the terminal board.
To mount the power supply cable, proceed as follows:
•Remove the wire clamp screw and the three contact screws 
•Fasten the wires beneath the screwheads using the fol- lowing colour scheme:
Blue (N) Brown (L) Yellow-Green 
•Secure the supply cable in place with the clamp and close the cover of the terminal board.
Connecting the supply cable to the mains
The appliance must be connected to a double pole isolating switch having a minimum contact separation of 3 mm. The supply cable must be in such a position that no part of it can reach a temperature of 50°C above room temperature. Before connecting to the power supply, make sure that:
•The electrical safety of this appliance can only be guar- anteed if the cooker is correctly and efficiently earthed, in compliance with regulations on electrical safety. Always ensure that the earthing is efficient; if you have any doubts call in a qualified technician to check the system. The manufacturer denies all responsibility for damage resulting from a system which has not been earthed.
•Before plugging the appliance into the mains, check that the specifications indicated on the rating plate (on the appliance and packaging) correspond to those of the electrical and gas mains of your home.
•Check that the electrical capacity of the system and sockets will support the maximum power of the appliance, as indicated on the data plate. If in doubt, consult a qualified technical engineer.
•If the socket and appliance plug are not compatible, have the socket replaced with a suitable model by a qualified technical engineer. The latter, in particular, will also have to ensure that the cross section of the socket cables are suitable for the power absorbed by the appliance. The use of adapters, multiple sockets and/or extensions, is not recommended. If their use cannot be avoided, remember to use only single or multiple adapters and extensions which comply with current safety regulations. In these cases, never exceed the maximum current capacity indicated on the single adapter or extension and the maximum power indicated on the multiple adapter. The plug and socket must be easily accessible.
15
