Hotpoint FDUD 43133 Ultima manual Special wash cycles and Options, Delayed Start option, Zone Wash

Models: FDUD 43133 Ultima

1 20
Download 20 pages 42.02 Kb
Page 13
Image 13
Special wash cycles and Options

Special wash cycles and Options

Notes:

Optimum performance levels when using the “Fast wash” and “Express 30’” cycles can be achieved by respecting the specified number of place settings.

To reduce consumption, only run the dishwasher when it is full.

Note for Test Laboratories: for information on comparative EN testing conditions, please send an email to the following address: assistenza_en_lvs@indesitcompany.com

Wash options*

The OPTIONS may only be set, changed or reset after the wash cycle has been selected and before the Start/ Pause button has been pressed.

Only the options which are compatible with the type of wash cycle set may be selected. If an option is not compatible with the selected wash cycle (see Table of wash cycles), the corresponding symbol flashes rapidly 3 times.

If an option is selected which is not compatible with another (previously selected) option, it will flash 3 times and switch off, while the most recently selected option will remain active. To deselect an option which has been set by mistake, press the corresponding button again.

Delayed Start option

It is possible to delay the start time of the cycle by a period of time between 1 and 24 hours:

1.Select the desired wash cycle and any other options required. Press the DELAYED START arrows to select when the wash cycle is to start (1h, 2h etc.)

2.Confirm the choice using the START/PAUSE button: the countdown begins and the display shows Begins in ...

3.Once this time has elapsed, the DELAYED START symbol switches off and the wash cycle begins.

To deselect the DELAYED START option, press the DELAYED START button until the text OFF appears.

The Delayed Start function cannot be set once a wash cycle has been started.

Zone Wash

GB

This option makes it possible to carry out the wash

 

cycle in the selected rack only. Select the wash

 

cycle and then press the ZONE WASH button: the selected

 

rack lights up and the wash cycle starts in the selected rack

 

only. Press the button again to deselect the option.

 

The option is available with the following wash cycles: Intensive and Normal.

Select the option and the Intensive cycle to start the ULTRAINTENSIVE ZONE washing. This wash cycle is ideal for very soiled mixed loads, e.g. pans and saucepans, dishes with heavy encrustation or difficult-to-clean crockery (grater, vegetable mill, dirty cutlery). The spraying pressure is stronger and the washing temperature higher, thus ensuring optimum handling of stubborn stains.

Select the option and the Normal cycle to start the SAVING ZONE washing. This function makes it possible to reduce energy consumption. Cycle duration might change.

Remember to load the crockery in the selected rack only.

ACTIVE OXIGEN option

This device releases ozone molecules into the dish- washer, i.e. a natural substance that reduces un-

pleasant odours.

It should be used between two different wash cycles and ONLY after soiled crockery has been loaded.

To start the ACTIVE OXIGEN option press and hold the but- ton O3.The option will stay active either for 24 hours or until the wash cycle is started. More items can be introduced at any time until full load.

The typical faint odour that can be smelt inside the dish- washer, the same as you sometimes get with storms is due to the ozone produced by lightning discharges. This is nor- mal. The device produces just a small quantity, which soon decays.

No replacement needed.

Multi-functional tablets (Tabs)

This option optimises washing and drying results. When using multi-functional tablets, press the MULTI- FUNCTIONAL TABLETS button; the corresponding symbol will light up. If the button is pressed again, the option will be deselected.

The “Multi-functional tablets” option results in a longer wash cycle.

The use of tablets is only recommended for models having this option and it is not recommended with wash cycles which do not specify the use of multi-functional tablets.

*Only available in selected models.

Extra drying

To improve the dryness level of the crockery, press the EXTRA DRYING button and the symbol will light up. If it is pressed again, the option will be deselected.

A higher temperature during the final rinsing and a longer drying phase improve the dryness level.

The EXTRA DRYING option increases the duration of the wash cycle.

Short Time

Delayed Start optionZone Wash This option can be used to reduce the duration of the main wash cycles while, maintaining the same washing and drying performance levels. After selecting the wash cycle, press the SHORT TIME button; the illumination of the corresponding indicator light indicates its selection.

Press it again to deselect it.

13

Page 13
Image 13
Hotpoint FDUD 43133 Ultima manual Special wash cycles and Options, Delayed Start option, Zone Wash, ACTIVE OXIGEN option