Hotpoint G740 mm Fastening Clamps Assembly Diagram, =20mm top =30mm top Front, Check the Seal

Installation

55mm

475 mm

555 mm

Fastening Clamps - Assembly Diagram

Clamp Position for	Clamp Position for
H=20mm top	H=30mm top
	Front

Clamp Position for

H=40mm topBack N.B: Use the clamps contained in the "accessory kit."

f)In the event the hob is not installed above a built-in oven, a wood panel must be inserted as insulation.This panel must be placed at least 20 mm from the bottom of the hob itself.

Important: When installing the hob above a built-in oven, the oven should be placed on two wooden strips; in the case of a joining cabinet surface, remember to leave a space of at least 45 x 560 mm at the back.

.	45	mm.
mm
560

When installing the hob above a built-in oven without forced ventilation, ensure that there are air inlets and outlets for ventilating the interior of the cabinet adequately.

Gas Connection for the Hob

The hob should be connected to the gas supply by an authorized installer. During installation of this product it is essential to fit an approved gas tap to isolate the supply from the appliance for the convenienceofanysubsequentremovalorservicing.Connection of the appliance to the gas mains or liquid gas tanks must be carried out according to the safety standards currently in force, and only after it is ascertained that it is suitable for the type of gas to be used. If not, follow the instructions indicated in the section entitled, “Adapting the Hob for DifferentTypes of Gas”.If the hob is to be connected to tanks containing liquid gas, use pressure regulators that comply with current safety standards.

Important:To insure that the appliance operates safety, the gas is regulated correctly and your appliance lasts over time, make sure that gas pressure levels comply with the indications given inTable 1, “Nozzle and Burner Specifications”.

Gas Connection to Non-flexible Pipe (copper or steel)

Connection to the gas source must be done in such a way as to not create any stress points at any part of the appliance.

The appliance is fitted with an adjustable, "L" shaped connector and a gasket for the attachment to the gas supply. Should this connector have to be turned, the gasket must be replaced (supplied with the appliance).

The gas feed connector to the appliance is a threaded, male 1/ 2" connector for round gas pipe.

Gas Connection to Flexible Steel Pipe

The gas feed connector to the appliance is a threaded, male 1/2" connector for round gas pipe. Only use pipes, tubes and gaskets that comply with current safety codes. The maximum length of theflexiblepipesmustnotexceed2000mm.Oncetheconnection has been made, ensure that the flexible metal tube does not touch any moving parts and is not crushed.

Check the Seal

Once the hob has been installed, make sure all the connections are properly sealed, using a soapy water solution. Never use a flame.

Adapting the Hob for DifferentTypes of Gas

To adapt the hob to a different type of gas than that for which it wasdesigned,(seethestickerunderthehoboronthepackaging), the burner nozzles must be changed, as follows:

•Remove the pan supports and slide the burners out of the cooktop.

•Unscrewthenozzlesusinga7mmsocketwrenchandreplace them with those for the new type of gas. (See table 1, “Burner and Nozzle Specifications”).

•Reassemble the parts following the instructions in reverse order.

8