Installation
•On completing the operation, replace the old rating label with
the one showing the new type of gas; the sticker is available from Hotpoint Service (see KEY CONTACTS, back page).
If the gas pressure is different than that prescribed, a pressure regulator must be installed at the source, in compliance with national standards governing the use of piped gas regulators.
Regulation of Air Supply to the Burner
The burners do not need a primary air regulator.
Minimum Regulation
•Turn the gas valve to minimum.
•Remove the knob and turn the regulator screw (positioned either on the side of the top or inside the shaft) clockwise until the flame becomes small but regular.
N.B.: In the case of liquid gas, the regulation screw must be fully screwed in (clockwise).
•Make sure that, when the knob is turned rapidly high to low, the flame does not go out.
9
