Hotpoint GF960, GF941 How To Use Your Hob, Gas Burners, On those models fitted with an ignitor D

Models: GF960 GF941

1 20
Download 20 pages 4.55 Kb
Page 7
Image 7
How To Use Your Hob

How To Use Your Hob

The position of the corresponding gas burner is indicated on each control knob.

Gas Burners

The burners differ in size and power. Choose the most appropriate one for the diameter of the cookware being used. The burner can be regulated with the corresonding control knob by using one of the following settings:

• Off

High

Low

On those models fitted with an ignitor (D),

To light a burner, simply press the corresponding knob all the way in and then turn it in the counter-clockwise direction to the "High" setting, keeping it pressed in until the burner lights.

As they are fitted with a flame failure device (F), the knob must be pressed in for about 6 seconds until the device that keeps the flame lighted warms up.

Caution: If the burner accidently goes out, turn off the gas with the control knob and try to light it again after waiting at least 1 minute.

To turn off a burner, turn the knob in the clockwise direction until it stops (it should be on the “•” setting).

Griddle (model GF941B only)

The griddle can be regulated by turning the corresponding knob in the clockwise or counter-clockwise direction to any of the 12 possible settings:

0Off

1Low

2-11Medium

12High

When the knob is on any of the settings other than "Off", the "H" operating light comes on.

Ceramic Glass Module (model GF941V)

This cooktop is fitted with dual-ring radiant heating elements located beneath the glass. It is possible to turn on only the circular part of the elemement (identified by the letter "A") or the cooking surface can be enlarged by turning on both "A" and "B". To turn only the circular "A" element, simply turn the knob in the clockwise direction to any one of the 12 available settings. To add the "B" section, turn the knob to setting 12 and then click it into the Gas BurnersOn those models fitted with an ignitor (D), setting. Then proceed by turning the knob in the counter-clockwise direction to one of the 12 settings.

The figure shows the heating zones, which become red when the element is turned on.

A. Circular heating zone;

B.Extended heating zone;

C.Indicator light to show when the cooking zone is above 60°C, even after the heating element has been turned off.

B

A

C

 

When the knob is on any of the settings other than "Off", the "H" operating light comes on.

7

Page 7
Image 7
Hotpoint GF960, GF941 manual How To Use Your Hob, Gas Burners, On those models fitted with an ignitor D