Installation Instructions
Unpacking the Cooker
Levelling
Stability Bracket
Connecting To The Gas Supply
Unpack the components from inside the grill and oven: Check that the following parts are present.
Grill pan and grid | Grill pan handle |
Pan supports (2) | Oven shelves (2) |
Enamelled discs (4) | Aluminium burner bodies (4) |
Literature | Battery 1.5V |
Four skid feet are fitted which can be adjusted up or down to level the cooker.
Caution: Some soft floor coverings may get damaged if the cooker is not moved carefully.
The cooker must be fitted with a stability device firmly secured to the fabric of the building. One of the holes in the rear panel can be used to engage a stability bracket.
The bracket must be |
|
fitted to the wall behind the |
|
cooker. The diagram is a |
|
guide to the correct height |
|
at which the bracket should | 155mm |
be from the floor. | Floor to bracket. |
The cooker is designed to match the depth of standard 600mm worktops. An adaptor backplate should, therefore, be fitted within the shaded area shown to allow the cooker to be pushed fully to the wall. If a forward facing backplate is used, it must be chased into the wall.
250
250
680680 | 500 |
250 | 550 |
250 |
Connection to the cooker should be made with an approved appliance flexible connection to BS 669. Hoses connected to the L.P.G. models should be suitable for L.P.G. and capable of withstanding 50mbar pressure. A length of 0.9 to 1.25m is recommended. The length of hose chosen should be such that when the cooker is in situ, the hose does not touch the floor.
The temperature rise of areas at the rear of the cooker that are likely to come in contact with the flexible hose do not exceed 70˚C.
21
