Hotpoint HDA2000M warranty Before you call for service, Display What IT Means What to do

.

	DISPLAY		WHAT IT MEANS		WHAT TO DO
	l-l=			This can be caused by either of
	I	/	these reasons:
--
				Not enough water is entering the	Unlatch the door. If there is no water in the bottom of the
			dishwasher.		dishwasher, check the water supply to the dishwasher.
					● Is the dishwasher water supply turned on?
					(Valve usually located under the sink.)
				or	c Is the household water supply turned on?
					● If you use well or cistern water, is the supply adequate?
					If the water supply is adequate, try the cycle again. If ES
					repeats, call for service.
				The drain pump could be	Unlatch the door. If there is standing water in the bottom of
				temporarily blocked (usually	the dishwasher, relatch the door. Touch “START;’ then
				caused by food particles such	immediately touch “CLEAR/RESET” to start the pump.
				as cereal).	If ES continues to appear, you may need to do this several
					times to breakup the blockage.
--				The temperature sensor in the	The temperature sensor needs to be replaced. Call for
	L(/
				dishwasher is not functioning	service.
				properly. Dishwasher may	N~E:
				continue to be used, but it will
					You may continue to use your dishwasher. For best results,
				not heat water automatically.
					adjust your household water heater thermostat to 140°F.
—

Before you call for service

. Try the cycle again to see if the Code reappears. The dishwasher may correct itself.

. Electronic controls can be affected by outside interference.

●Sometimes shutting off the power to the dishwasher (at the fuse or circuit breaker) will correct the problem.

●Restore power after about five seconds and try the cycle again.

. Check the chart above for things you can do to correct the problem.

9

—