Hotpoint MWH211 manual Electrical Connection, Earthed

We recommend the following for this oven:

ELECTRICAL CONNECTION

A)If your appliance comes fitted with a plug, it will incorporate a 13 Amp fuse. If it does not fit your socket, the plug should be cut off from the mains lead, and an appropriate plug fitted, as below.

WARNING: Very carefully dispose of the cut

off plug after removing the fuse: do not insert in a 13 Amp socket elsewhere in the house as this could cause a shock hazard.

With alternative plugs not incorporating a fuse, the circuit must be protected by a 15 Amp fuse.

WARNING - THIS APPLIANCE MUST BE

EARTHED

IMPORTANT

The wires in the mains lead are coloured in accordance with the following code:

Green and yellow:	Earth	E
Blue:	Neutral	L
Brown:	Live	N

If the plug is a moulded-on type, the fuse cover must be re-fitted when changing the fuse using a 13 Amp Asta approved fuse to BS 1362. In the event of losing the fuse cover, the plug must NOT be used until a replacement fuse cover can be obtained from your nearest electrical dealer. The colour of the correct replacement fuse cover is that as marked on the base of the plug.

B)If your appliance is not fitted with a plug, please follow the instructions provided below:

As the colours of the wires in the mains lead may not correspond with the coloured markings identifying the terminals in your plug, proceed as follows:

The green and yellow wire must be connected to the terminal in the plug marked with the letter E

or the earth symbol or coloured green or green and yellow.

The blue wire must be connected to the terminal marked with the letter N or coloured black. The brown wire must be connected to the terminal marked with the letter L or coloured red.

Data and instruction for Performance Tests according to IEC 60705 and EN 60705 (19999-04)

The International Electrotechnical Commission SC 59H, has developed a Standard for comparative testing of heating performances of microwave ovens.

Test Nr.		900w	700w		Power			Standing
on	Item	output power	output power	Function			Weight		Note
						level		time
standard		Duration	Duration
12.3.1	Egg	14’ - 16’	18’ - 20’	only			750 gr	5 min.	The upper surface shall be evaluated after the
	custard			MW					standing time. The inner custard evaluation shall
									be conducted after two hours.
	Sponge			only					Use the borosilicate glass container stated in the
12.3.2		6’ - 7’	8’ - 9’				475 gr	5 min.	Standard (max dia. 210 mm) or a Pyrex® glass
	cake			MW					container dia. 210 mm, height 50 mm and wall
									thick. 6mm.
	Meat			only					Cover the container with cling film and pierce the
12.3.3		18’ - 20’	22’ - 24’				900 gr	5 min.	film. Use the rectangular borosilicate glass container
	loaf			MW					stated in the Standard or the Arcopal® Cat. nr
									Z1/B8 (01)10460-1
13.3	Defrosting	6’ - 8’	9’ - 11’	only			500 gr	15 min.	Place the frozen load directly on the turnable (D).
	minced			MW					Turn upsidedown the load after half of the
	meat								defrosting time.

2