Installation
Choosing a Location
The freezerwill operatein temperaturesup to +32'C.
The freezer should be placed in a dry, ventilated room and never close to a radiator or other sources of heat, as this will increase the power consumption unnecessarily. Please make sure that the freezer is installedon a level surface and in a position providing adequate air circulation to the sides and rear of the freezer (minimum clearance of 25mm, 1" each side) also make sure the lid can be opened fully.
If the freezer is installed on a thick pile carpet it should be elevated to ensure free air circulation underneath.
The freezer should not be positioned where it will be affected by draughts or dampness. The siting of freezers in unheated outhouses or garages may. in cold weather, give rise to condensation forming on the outer surface of the freezer. This is no way due to faulty operation of the freezer and will disappear with wanner weather.
Remove condensation with a clean, dry cloth.
Before Using your Freezer
It is recommended that you clean both the Inside and the outside of the freezer before using it for the first time. Use lukewarm water and a little bicarbonate of soda;
1 teaspoon to 1.2 litres of water.
NOTE: The freezer should be allowed to standfor 12 hours, to allow the system to settle, before it is turned on for the first time.
Fitting Sliders to Base of the Freezer
Four sliderscanbefittedto the baseofthe appliance- oneat eachcomer
Place protective material between the floor and the freezer (eg. the freezer packaging) Tilt or lie the freezer on a side - DO NOT lie the freezer on its front, you will damage
the handle or on its back, you will damage the compressor.
Place the slider housing the correct way into the aperture and push into position (see diagram below).
.,
