Hotpoint dimensions RVM1335WC-Hotpoint 1.3 Cu. Ft. Counter Saver Plus Microwave Oven

RVM1335WC—Hotpoint 1.3 Cu. Ft. Counter Saver Plus™ Microwave Oven

Dimensions (in inches)

66" MIN.	30"
Mounting	MIN.
height	width
from	required
floor
	12"
	MAX.

14"

16-1/2"

21-3/4"	15-7/	8"
Door open

Exhaust outlet

connects to

3-1/4" X 10" duct

Optional Accessories (Available at additional cost)

12” Filler Panel Kits

JX41–Black Filler Panel Kit

JX40WH– White Filler Panel Kit

When replacing a 36" or 42" range hood, this kit fills in the

additional width to provide a custom, built-in appearance. For installation between cabinets only; not for end-of-cabinet installation. Each kit contains two, 3"-wide filler panels. Two kits are needed for a 42" opening.

JX81A–Recirculating Charcoal Filter Kit

To be used when the Counter Saver Plus™ microwave oven cannot be vented to the outside.

Important Information: When installing the Counter Saver Plus™ microwave oven over a range, allow minimum of 2" from bottom of Counter Saver Plus™ microwave oven to top of range backguard to allow for removal of light covers.

Installation Information: This information is not intended to be used for installing unit described. Before installing, consult installation instructions packed with product/kit for current dimensional data.

Ventilation Options: The Counter Saver Plus™ microwave oven is designed for adaptation for the following three types o ventilation:

Outside Exhaust (Vertical–as shown above) Outside Exhaust (Horizontal)

Recirculating Exhaust (Non-vented ductless–see Filter Kit Drawing)

Note: Before Installing, comsult installation instructions for curent dimensional data on these therr types of ventilation

Specification Revised 6/00

Listed by

Underwriters

RLaboratories