Hotpoint SC52-FC52 Instalation, Installation of Built-in Ovens, Fastening the oven to the cabinet

Instalation

The appliance must be installed only by a qualified person in compliance with the instructions provided. The manufacturer declines all responsibility for improper installation which may harm persons and animals and damage property.

Important: The power supply to the appliance must be cut off before any adjustments or maintenance work is done on it.

Installation of Built-in Ovens

In order to ensure that the built-in appliance functions prop- erly, the cabinet containing it must be appropriate. The figure below gives the dimensions of the cut-out for instal- lation under the counter or in a wall cabinet unit.

The panels of the adjacent cabinets must be made of heat- resistant material. In particular, cabinets with a veneer ex- terior must be assembled with glues which can withstand temperatures of up to 100 °C.

In compliance with current safety standards, contact with the electrical parts of the oven must not be possible once it has been installed.

All parts which ensure the safe operation of the appliance must be removable only with the aid of a tool.

Fastening the oven to the cabinet

1.Place brackets “A” up against the oven support “ B”.

2.Place the tabs “C” up against brackets “ A”. In particular, if the cabinet side panel:

595 mm.	23 mm.
	567 mm.
	5 mm.

		.
45	mm
	558	mm.

593 mm.

•is 16 mm thick: mount the tab so that the number 16 it features is facing you;

•is 18 mm thick: mount the tab so that the part without any wording is facing you;

•is 20 mm thick: do not mount the tab.

3.Fasten the brackets and tabs on the oven cabinet side panel using screws “D”.

4.Fasten the oven to the cabinet using the screws and plastic washers “E”.

595	mm.		.
		545	mm
	.
	mm
24

16

16

D C

C

D

A

E

N.B.: Installation in compliance with the consumption declaration

	.
45	mm
	.
min

mm.595			23 mm.	.mm567			585-575mm.	595mm.		.
					558				45	mm
						mm.				.
										min
			5 mm.
	595	mm.		.
			545	mm
		.
		mm
	24

In order to ensure adequate ventilation, the back panel of the cabinet unit must be removed. Installing the oven so that it rests on two strips of wood is preferable. If the oven rests on a continuous, flat surface, there must be an ap- erture of at least 45 x 560 mm.

.	45	mm.
mm
560

16

16

B

C

D

E

12