Hotpoint SD97PC, SD97PI manual Electrical Connection, 1 2 3 4 LN

Models: SD97PI SD97PC

1 20
Download 20 pages 61.86 Kb
Page 16
Image 16
Electrical Connection

Electrical Connection

Electrical connection

The electrical connection to the mains must be made on the appliance. The power voltage and frequency are as indicated on the rating plate.

WARNING: THIS APPLIANCE MUST BE EARTHED.

Mounting the power supply cable

To open the terminal board:

Using a screwdriver, press on the tabs situated on each side of the terminal board cover.

Pull open the terminal board cover.

To mount the power supply cable, proceed as follows:

Unscrew the cable clamp screw and the contact screws.

Position the jumpers accordingly to the type of connection you wish to make as per the diagrams below.

Note: The jumpers are factory set for a 230V single phase connection.

Electrical Connections:

1 2 3 4 5

LN

Voltage Frequency: 230 V-1+N - 50Hz

Fuse Section: 32A - 4mm3

You can connect your oven to the system means of a terminal board. Refer to above information for the minimal cable sections and the calibration of the protective elements according to the connection.

If the appliance is installed with a junction box, an omnipolar circuit breaker - with a minimum contact opening of 3mm - should be installed between the appliance and the mains.

Fasten the power supply cable in the corresponding cable clamp and close the cover.

Power cable supply connection to the electrical mains:

We recommend you use a power supply cable which is long enough to allow you to take the oven out of its recess in the event of maintenance operations (only use HAR - H 05 - RRF quality cables fitted with a plug conforming to the regulations in force.

The plug must be accessible at all times.

Unplug the appliance before all operations, even when replacing the oven lamp.

Using the appliance without correct earthing is highly dangerous.

IMPORTANT:

After connecting the appliance to the flexible cable, tighten all the screws on the terminal board.

This appliance conforms to the following EEC Directives:

Low Voltage Equipment 73/23/EEC 93/68/EEC

Electromagnetic Compatibility 89/336/EEC

93/68/EEC

Inner dimensions of the oven:

 

width

43.5cm

depth

40.0cm

height

32.0cm

Inner volume of the oven:

54 litres

Voltage and frequency of power supply:

230-240V

50-60Hz

2250-2400W

GB

16

Page 16
Image 16
Hotpoint SD97PC, SD97PI manual Electrical Connection, 1 2 3 4 LN