GB | CONNECTION TO THE GAS SUPPLY |
|
|
The supply system must be compliant with the current standards in the country of use. The type of gas for which the oven has been regulated is indicated on the serial number plate located on one of the side edges of the cavity (visible with the door open) and on the packaging. Before carrying out the connection, the oven must be adapted to the type of gas that will be used.
Link the male cylindrical threaded
side of the appliance to the supply, by using a
Otherwise you can use a flexible metallic pipe entirely fixed to the wall and pipe- fittings which are compliant with the current standards; the length of the pipe cannot be over 2000 mm, in compliance with the current standards.
Check that the pipe cannot come in contact with movable parts that could damage it.
Place the seal (fig. 1) between the
Important: to conenct the appliance to a LPG supply, place a pressure regulator which is compliant with the current standards between the pipe and the gas tank.
Attention: when finished, check that there are no gas leaks.
Use soap and water or special liquids to make sure that there are no gas leaks.
DO NOT USE OPEN FLAMES WHEN SEARCHING FOR GAS LEAKS.
Warning: the use of a rubber flexible hose fastened with hose clamps is prohibited because it cannot be inspected.
Fig. 1
Ramp | Seal | Gas pipe |
______ | ______ | ______ |
8
