HP Deskjet ZONE, Status, Feature, Command, Comments, AppleTalk, Configuration, ?&b#WZONE<sp>zonename

Table 2-14. PCL Feature Additions for HP Color LaserJet Printer (continued)

Feature	Status	Comments
PC (Pen Color—HP-GL/2)	New	Changes the pen color in a palette created by the IN or CID
		command (?*v#W).
Push/Pop Palette	New	Pushes or pops the palette from the palette stack.
Raster Scaling	New/Modified	Several commands are added for raster scaling: Destination
		Raster Width (?*t#H), Destination Raster Height (?*t#V);
		also, two parameters are added to the Start Raster Graphics
		command to initiate scaling (?*r2A and ?*r3A). (See the PCL
		5 Color Technical Reference Manual for more information.)
Render Algorithm	New	Selects the algorithm to be used for rendering page marking
		entities on a given page.
Select Palette by ID	New	Activates a palette with the specified ID number.
Set Viewing Illuminant	New	Specifies the relative white point used in the determination of
		a viewing illuminant condition.
Simple Color	New	Specifies an unmodifiable fixed-size palette.
Transfer Raster Graphics (by	New	Provides a means to send raster data by color plane. This
plane)		command sends a plane of raster data to the printer and
		advances to the next plane.

AppleTalkConfiguration

Command

As discussed in the HP LaserJet 4 section of this chapter, the AppleTalk Configuration command allows a user to send PCL jobs to the printer over AppleTalk. In addition to the key values previously discussed (RENAME, TYPE, and JOB), the HP Color LaserJet printer also supports the ZONE key value as follows.

ZONE

ZONE changes the zone field of the printer’s AppleTalk Network Identifier (Name Binding Protocol type field).

?&b#WZONE<sp>zonename

Valid characters for the zone name include 0-255 except for characters $00, “@” ($40), “:” ($3A), “*” ($2A), “=” ($3D), $C5, and ($FF). The zone name must contain at least one character, and only the first 31 characters are used. If the zone is invalid, then the printer’s zone is not changed. Zone changes only occur after the present job has completed.

Printer-Specific Differences 2-71