Engine Identification Numbers
When ordering parts, or in any communication involving an engine, always give the Model, Specification, and Serial Numbers of the engine.
The engine identification numbers appear on a decal (or decals) affixed to the engine shrouding. Include letter suffixes, if there are any.
Record your engine identification numbers on the identification label below (Figure 5) for future reference.
MODEL NO.
SPEC. NO.
DISPL (CC)
SERIAL NO.
REFER TO OWNER'S MANUAL FOR SAFETY, MAINTENANCE SPECS AND ADJUSTMENTS. FOR SALES AND SERVICE IN US/CANADA CALL:
KOHLER CO. KOHLER, WI USA
IMPORTANT ENGINE INFORMATION
THIS ENGINE MEETS U.S. EPA
PHASE 1 AND
CALIFORNIA EMISSION CONTROL
REGULATIONS FOR SORE*
FAMILY
MODEL NO.
SPEC. NO.
DISPL (CC)
SERIAL NO.
REFER TO OWNER'S MANUAL FOR SAFETY, MAINTENANCE SPECS AND ADJUSTMENTS. FOR SALES AND SERVICE IN US/CANADA CALL:
KOHLER CO. KOHLER, WI USA
If your engine has this identification label, it is certified to meet EPA/CARB standards.
*Small Off-Road Engines
Figure 5. Engine Identification Labels.
Operating Instructions
Also read the operating instructions of the equipment this engine powers.
Pre-Start Checklist
•Check oil level. Add oil if low. Do not overfill.
•Check fuel level. Add fuel if low.
•Check cooling air intake areas and external surfaces of engine. Make sure they are clean and unobstructed.
•Check that the air cleaner components and all shrouds, equipment covers, and guards are in place and securely fastened.
•Check that any clutches or transmissions are disengaged or placed in neutral. This is especially important on equipment with hydrostatic drive. The shift lever must be exactly in neutral to prevent resistance which could keep the engine from starting.
WARNING: Lethal Exhaust Gases! Engine exhaust gases contain poisonous carbon monoxide. Carbon monoxide is odorless, colorless, and can cause death if inhaled. Avoid inhaling exhaust fumes, and never run the engine in a closed building or confined area.
Cold Weather Starting Hints
1.Be sure to use the proper oil for the temperature expected. See Figure 3 on page 5.
2.Disengage all possible external loads.
3.Set speed control at part throttle position.
4.Be sure the battery is in good condition. A warm battery has much more starting capacity than a cold battery.
5.Use fresh winter grade fuel. NOTE: Winter grade gasoline has a higher volatility to improve starting. Do not use gasoline left over from summer.
Starting
CH18-26 Engines:
1.Place the throttle control midway between the ‘‘slow’’ and ‘‘fast’’ positions. Place the choke control
6